Capricorn Christmas Light Tester Manual Transmission

Best Answer: Christmas Light Tester Item Number: TD24 28540 This Christmas Light Tester will allow you to easily find any burned out bulbs on your Christmas lights. With a push of a button you can locate your Christmas light string problem. The Christmas light tester will test bulbs, fuses, and the light strand. The light tester has a built in bulb remover to remove bulbs from the light set easily. The Christmas light tester comes with 2 “LR44” watch batteries. Instructions on use and care of the Christmas light tester are included. To use the light tester, remove the battery cover and insert the 2 batteries into the battery compartment.

Replace the batter cover and test the batteries by holding down the push button for 4 seconds. How To Use Sims 2 Clean Pack Installer there. If the LED flashes on then off the batteries are okay. If the LED does not flash, check the batteries are correctly installed, clean, and in good condition. To remove bulbs using the Bulb Remover, simply insert the metal plate between the bulb husk and the bulb base. Gently rotate the bulb remover to the left and right until the bulb is loose enough to pull out with your fingers.

Note: Some light strands have what is known as a “locking” base or clip. These require you to unlock the bulb husk from the base in order to remove the bulb. If you are unsure if you have locking bases on your light strand, then refer to the light strand manufacturer’s instructions on bulb removal. Games Spider Solitaire Download Free on this page. To test the light bulbs simply remove the bulb using the bulb remover. Hold the bulb by the tip and gently push the 2 wire contacts against the two metal plates located on the bulb tester.

Simple tester checks Christmas-tree lights. William Dias, Brown&Sharpe. It's convenient to house the tester in a clear piece of plastic tubing. Dec 04, 2011 Instructions for Capricorn Electronics Christmas light string tester DPT1? Capricorn Electronics. Can Christmas fears and anxiety be overcome. Interview Questions and Answers, Job Interview Tips, Advice, Guide. Job interview questions and sample answers list, tips, guide and advice. Helps you prepare job.

Both of the wire contacts should be touching separate metal plates. If the light bulb lights, then it is good. Windows 7 Starter Iso German Usb Charger on this page. If the light bulb does not light, try readjusting the wire contacts on the base of the bulb and test the bulb again. If the light bulb still does not light, then discard the bulb. Repeated bulb testing or holding lit bulbs against the light tester for long periods of time will drain the batteries rapidly. To test the light fuses simply remove the fuses from the light strand. Hold the fuse in the middle and gently press it against the Fuse Tester.